News

　　Thermoluminescent dose readerAs a precise scientific instrument, it plays a vital role in many fields of modern society. Through an in-depth understanding of it, we can not only better use this technology to protect human health and environmental safety, but also promote the development of related science and technology and lay a solid foundation for future innovation.
 

　　Maintenance methods for thermoluminescence dose readers mainly include preliminary preparation, sample processing, equipment inspection and maintenance, data recording and analysis, and regular calibration and calibration. The following is a detailed introduction:
 

　　1.Preliminary preparation
 

　　-Read the instruction manual: Before use, the operator should read the equipment instruction manual carefully to understand the operating procedures and safety precautions of the equipment.
 

　　-Environmental inspection: Make sure the environment of the equipment and operating area is clean and dry to avoid dust and moisture affecting the measurement results.
 

　　- Accessory inspection: Check whether the equipment accessories are complete and whether they can work normally. In particular, check whether the magnetic ring of the sample bowl is twisted and deformed, whether there are cracks in the sample bowl, and whether the sample bowl and the thermoluminescent powder are in close contact, etc.
 

　　2. Sample processing
 

　　-Protective measures: During the operation, operators should wear protective equipment such as gloves, masks, and goggles to prevent harm to personnel caused by radioactive materials present in the samples.
 

　　-Sample processing: During sample processing, care should be taken to avoid sample contamination and keep the instrument and laboratory clean.
 

　　3. Equipment inspection and maintenance
 

　　- Regular inspections: Regularly check the working status of the equipment and detectors of the thermoluminescence dose reader, and perform necessary maintenance and upkeep to ensure the normal operation of each component.
 

　　-Exception handling: When an abnormality occurs in the machine, the power should be turned off immediately and maintenance personnel should be notified in time for maintenance.
 

　　4. Data recording and analysis
 

　　-Record and archive: Record the measured radiation dose value, and indicate the measurement time, location, radiation source and other information.
 

　　-Data analysis: When performing data analysis on the measured thermoluminescence signal, carefully check the accuracy and reliability of the analysis results.
 

　　5. Regular calibration and calibration
 

　　-Calibration cycle: regular inspectionThermoluminescent dose readerThe working status of the equipment and detectors, and calibration and calibration. The calibration and calibration cycle depends on the frequency of use and accuracy requirements, usually six months to one year.
 

　　-Exposure verification: In order to ensure its sensitivity and accuracy, it is recommended to perform dose calibration and exposure regularly. The exposure dose should be determined based on the frequency of use and the radiation level of the working environment, generally once every six months to one year.